Table of Contents
Advertisement
Before Y Y ou C C onfigure K K P
The following sections of this manual assume that you have an active printer established on your
Unix/Linux system and that you have installed KP. If this is not the case, please create an active printer
session for your system now and install KP. Please refer to the readme.txt file that came with your KP
distribution for detailed installation instructions (see page 5 for details).
Since Konica Print Utility is fully customizable, its configuration will differ based upon the Konica
Workgroup Document System that you use. The configuration in this manual is intended solely as a guide,
from which you may learn the basis of configuration.
The configuration in this manual is based upon a Konica 7065 Workgroup Document System with
an FS-106 Finisher, an LT-352 large capacity tray, 32 MB ERDH RAM and an IP-303 with
64 MB of RAM.
The Konica 7065 has many popular features that are available on other Konica Workgroup Document
Systems. The fundamental processes for configuring and using these features within KP are the same for
all Konica printers.
To properly configure your Konica printer, you need to know what Konica printer model you have and the
optional accessories installed on it. If you are unsure about your printer and its installed accessories,
please contact your Konica representative.
Konica Print Utility 7
Advertisement
Table of Contents
