Connecting To A Camera - Honeywell HBD2FR1 User Manual

Connecting to a Camera

When you open the IP Utility, the devices on the network—including devices on other
subnets—are automatically discovered and listed in the Discovery pane on the left of the
screen. After the initial discovery, the list of discovered devices auto-refreshes at regular
intervals. You can manually refresh the list by clicking
To connect to a network camera
•
If the connection is successful, the message Connected to Device [device name]
appears in the status bar at the bottom of the screen.
If the connection is unsuccessful,
Discovery pane. Check the the network settings of the camera and the workstation. The camera
must be on the same subnet as the workstation. Contact your network administrator for
additional support.
To disconnect from a network camera
•
In the Discovery pane, double-click the camera you want to connect to. Alternatively, click
the camera name, and then click
When connecting to an ONVIF camera for the first time, the ONVIF credentials login
window appears (see
Figure
Figure 3-3 ONVIF Login Window
In the Discovery pane, click the camera you want to disconnect from, and then click
(Disconnect).
If you try to disconnect without saving configuration details, you will be prompted to save
your changes. Click Yes to save the changes and disconnect. Click Cancel to discard the
changes and disconnect.
Installing the Honeywell IP Utility | 29
(Refresh).
(Connect).
3-3). Enter your user name and password, and then click OK.
(Limited/No Connectivity) replaces (Connect) in the
800-13338 - A - 03/2013