Honeywell HBD2FR1 User Manual page 61

In cameras with a wide field of view, or where activity happens far away from the camera,
people and vehicles might appear rather small in the image and it might not be possible to
apply a single area of interest to the whole field of view and reliably detect motion. In such
cases, it is recommended that several smaller region-of-interest boxes be applied to areas
where motion alarms are of most interest to the user such as entrances, restricted access
areas, and so on.
3. Use the medium sensitivity at 50% as the initial setting. This setting can be changed later
as needed (see
Adjusting Video Motion Detection Sensitivity
4. Observe VMD performance in all expected lighting conditions after the initial configuration
is applied. Ensure that relevant scene motion does trigger alarms and ensure that the
camera is not reporting false alarms (such as VMD alarms triggered due to image noise).
Setting Video Motion Detection
To set video motion detection
1. Next to Region, select one of the following:
• Region 1 (Red)
• Region 2 (Green)
• Region 3 (Blue)
• Region 4 (Magenta)
• Region 5 (Cyan)
2. Next to VMD, select Enable.
A box corresponding to the region you selected in step 1 appears on the video display in
its default location.
3. If you want, you can move and resize the box.
a. To move the box, click inside the box and drag it to a new location on the screen.
b. To resize the box, hover your mouse over one of the sides of the box until the mouse
pointer becomes a double-headed arrow. then drag the side to its new position.
4. Next to Motion Threshold, select one of the following options:
• High (80%)
• Medium (50%)
• Low (30%)
5. Click Apply.
6. Repeat steps 1 to 5 to configure additional regions if desired.
7. To confirm that the VMD settings have been applied, go to another screen (such as
Camera Setup) and then return to the Video Analytics screen. Check that the VMD settings
have not changed.
Note To disable a region that you have configured, next to Region, click the region
that you want to disable, and then, next to VMD, select Disable.
Least sensitive to motion
Medium sensitivity to motion (recommended for initial setting)
Most sensitive to motion
Setting Up the Camera | 61
on page 62).
800-13338 - A - 03/2013