Figure 4-12 Secondary Stream Settings (H.264 Or Mjpeg) - Honeywell HBD2FR1 User Manual

50 | HBD2FR1(X) User Guide
To configure the Primary and/or Secondary stream compression settings, see
Apply to save your changes.
Setting
Resolution
Frame Rate
Priority
Compression
Ratio
www.honeywellvideo.com
Note To configure the secondary stream, either H.264 + H.264 or H.264 + MJPEG
must be selected as the codec type.
Figure 4-12 Secondary Stream Settings (H.264 or MJPEG)
Note Internet Explorer users only: Select the Statistics check box at the bottom of the
screen to monitor the received bit rate and received frame rate as you make
changes.
Table 4-7 Compression Settings
Options
Primary
1920×1080
1280×720
800×450
640×360
320×180
1–30 (NTSC)
1–25 (PAL)
Primary
Quality,
Bit Rate,
Frame Rate
Minimum, Low, Medium,
High, Maximum
MJPEG settings shown for NTSC models
Set the Resolution
Set the Frame Rate
Set the Priority to Quality or Bit Rate
Set the Compression Ratio
Set the Target Bit Rate
Set the Maximum Bit Rate (kbps)
Note GOP is not available if MJPEG is used
for the secondary stream.
Description
Secondary Sets the picture resolution.
1920×1080 (H.264)
1280×720 (H.264)
800×450 (H.264)
640×360 (H.264)
320×180 (H.264)
640×360 (MJPEG)
320×180 (MJPEG)
The number of frames displayed per second.
Secondary Sets whether picture quality, bit rate, or frame
Quality, rate has operational priority. For more
Bit Rate information, see
page 51.
Available when Priority is set to Quality.
Minimum provides the highest picture quality.
Maximum provides the lowest picture quality.
4-7. Click
Table
on
Configuring Priority Settings