FORCED
MODES
Configuration Menu Overview
Settings
AUTO/AUTO/ON / AUTO/FULL/ON /
AUTO/HALF/ON / 100M/AUTO/ON /
100M/FULL/ON / 100M/FULL/OFF /
100M/HALF/ON / 100M/HALF/OFF /
10M/AUTO/ON / 10M/FULL/ON /
10M/FULL/OFF / 10M/HALF/ON /
10M/HALF/OFF
Some network hubs will not communicate with printers that
use a fixed network speed and structure. In such cases, use
NETWORK/FORCED MODES
the new
printer for the appropriate hub settings and enable communi-
cation.
# The first value indicates the network transmission speed
SPEED
(
). Select from a 10Base-T connection (
100Base-TX connection (
(
AUTO
). If
AUTO
depending on the negotiation; therefore, there is no setting
where negotiation is turned off.
# The second value indicates the communication method for
bi-directional communication (
sent and received in both directions simultaneously (
or in one direction at a time (
recognition (
AUTO
speed is set depending on the negotiation; therefore, there
is no setting where negotiation is turned off.
# The third value indicates the negotiation (
(mutually sends and receives information such as the
transmission speed and determines the transmission set-
ting). When set to
to
OFF
, negotiation is not performed.
100M
), or automatic recognition
is selected, the transmission speed is set
DUP
). Select whether data is
HALF
), or select automatic
). If
AUTO
is selected, the transmission
ON
, negotiation is performed. When set
menu to configure the
10M
),
FULL
NEG.
) setting
)
33