Table of Contents
Advertisement
Connecting the Computer and Copier
7
Enter the IP address for the copier into the
Address
8
Select Custom, and then click [Settings].
9
Select
10
Enter "9100" for the
11
Click [Next>].
12
Click [Finish].
7.2.4
IPP Printing
Windows 2000/ Windows XP
Important
Before continuing to set up the network settings, check the following:
Check that the computer is set up to use the TCP/IP protocol.
Check that the copier is also set up to use the TCP/IP protocol.
Check the IPP Settings Using PageScope Light
Use PageScope Light to access the copier and check if IPP printing is
enabled. For instructions on using PageScope Light, refer to "8 Using
PageScope Light".
1
Start up PageScope Light.
2
Log in to the Administrator mode.
3
Click the "Network" tab, and then select "IPP Configuration" in the
menu.
4
Check that
not possible.
NC-6
box, and then click [Next>].
RAW
as the protocol.
Port Number
Enable IPP
is selected. If it is not selected, IPP printing is
Printer Name or IP
setting, and then click [OK].
7
7-7
Advertisement
Table of Contents
