Ice And Water Dispenser Bezel Installation - Viking DFBB363 Installation Manual

6
Insert handle-side door trim making sure to engage
handle-side "Z" bracket in door trim. Install door trim screws.
Custom Freezer Door Panel Installation (Bottom Mount Only)
1
Open freezer door. Remove door trim screws and door
trim with a phillips screwdriver.
3
Align panel in door trim and push down evenly.
Ensure side and bottom "Z" bracket engagement with door trim.
49
7
Reinstall cabinet trim and screws.
1/4"
off edges of
2 3/4 " panel
Install "Z" brackets onto back side of custom panel.
Note: If 1/4" back panel is used, the brackets will be flush to the
edge (back panel is 1/4" smaller than 3/4" panel dimension).
4
Reinstall top door trim and door trim screws with a
phillips screwdriver.
Ice and Water Dispenser Bezel Installation (if required)
1
Install custom wood panels per product's installation
instructions.
3
Push firmly into cavity until lower screw holes align with
mounting holes on cavity.
5
Position upper mounting support over holes
underneath top section of bezel.
50
2
Locate opening in door and position bezel.
Note: Graphics on bezel will be on top end, tilt slightly
forward to allow water tube clearance.
4
Install two screws in lower part of bezel
but do not tighten all the way.
6
Install two screws but do not tighten all the way.