Custom Door Panel Installation-Refrigerator; Custom Door Panel Installation-Freezer - Viking DFBB363 Installation Manual

5
Remove two additional screws under top
section of bezel.
7
Store bezel and spill tray in safe and secure place until
Grasping the bezel on both sides, pull away from
the door cavity.
Note: Bezel needs to be pulled from the bottom
first and then pull slightly downward to clear
the water dispensing tube.
For re-installation steps, see pages 50-51.
47
6
Remove mounting support.
3 8
installation.
Custom Door Panel Installation (Refrigerator or Freezer)
1
Remove handle side cabinet screws and trim
with a phillips screwdriver.
1/4"
off edges of
3 3/4 " panel
Install "Z" brackets onto back side of custom panels.
Note: If 1/4" back panel is used, the brackets will be
Note: A 1/4" back panel needs to be used to ensure proper
flush to the edge (back panel is 1/4" smaller than
3/4" panel dimension).
4
3 "
Align upper and lower "Z "brackets in door trim and For the last 3" of installation, push evenly on the custom wood panel
push custom wood panel evenly toward the hinge until near the side door trim in addition to pushing from the handle side.
approximately 3" from the hinge side door trim. This ensures side "Z" bracket engagement with hinge side door trim.
48
2
Remove handle side door trim screws and panel
with a phillips screwdriver.
Door trim
Door
"Z" bracket
1/4" (0.5 cm) back panel
3/4 " (1.9 cm) custom panel
TOP VIEW
Proper "Z "brackets engagement.
insulation. If back panel is not used, the potential for
condensation is present.
5