Electrical Safety; Switching On And Off - Black & Decker Dustbuster User Instructions

Electrical safety

#
This tool is double insulated;
therefore no earth wire is
required. Always check that the
power supply corresponds to
the voltage on the rating plate.
If the supply cord is damaged, it must

be replaced by the manufacturer or
an authorised Black & Decker Service
Centre in order to avoid a hazard.
Do not use the appliance to vacuum

any electrical appliances while they
are plugged in.
Features
1. On/off switch
2. Release button
3. Clogged filter indicator
4. Dust bowl
Fig. A
5. Brush tool
6. Crevice tool
7. Bowl adaptor
8. Floor head
9. Hose
10. Blow adaptor
11. Tubes
12. Tool adaptor
13. Blow diffuser
14. Small inflator adaptor
15. Medium inflator adaptor
16. Large inflator adaptor
Assembly
Warning! Make sure that the appliance
is switched off and unplugged.
Fitting the accessories (fig. A - G)
Fitting the accessories for vacuuming
The accessories provided can be used in
various combinations, depending on the
task (fig. B):
a. General vacuuming / dusting
b. Vacuuming in confined spaces
c. Vacuuming stairs
d. Vacuuming upholstery
e. Vacuuming in corners
Downloaded From Vacuum-Manual.com Manuals
6
f. Vacuuming carpeted floors
g. Vacuuming hard floors
The brush tool (5) and the crevice tool (6)
are stored at the underside of the
appliance. To fit an accessory, proceed
as follows (fig. D):
Take the accessories from the

appliance.
Insert the appropiate accessory into

the front of the appliance.
Fitting the accessories for blowing
and inflating
The accessories provided can be used in
various combinations, depending on the
task (fig. C):
a. Blowing
b. Inflating
To increase your working range, it is also
possible to fit the tubes to the end of the
hose.
To fit the accessories, proceed as follows
(fig. E & F):
Open the exhaust filter holder (17).

Insert the blow adaptor (10) into the

opening (18). Make sure it fits snug
against the rear of the appliance.
Insert the other accessories as shown.

For inflating purposes, fit an inflator
adaptor to the hose (fig. G):
Align the tab (19) on the adaptor with

the hole (20) in the hose end.
Push the adaptor on the hose until it

clicks into place.
To remove the adaptor, lift up the tab

and pull the adaptor off the hose.
Use
Warning! Before connecting to the
power supply, make sure that the
appliance is switched off.

Switching on and off

To switch the tool on, set the on/off

switch (1) to position I.
To switch the tool off, set the on/off

switch to position O.
Warning! Make sure the accessories are
securely attached before switching on.