Create Zone; Edit Zone; Delete Zone - infinias S-IMS-A Intelli-M Installation And User Manual

Door Behaviors can be deleted only when there are no Doors configured to use this Behavior. If you get an error popup dialog
NOTE
indicating that one or more Doors are configured for this Behavior, assign a different Behavior to those Doors, then delete
the Behavior.

4.6.11 Create Zone

Select the Zones View, then click the Create Zone Action to create a Zone. A Create New Zone popup dialog is shown below:
To create a Zone:
Enter a Zone Name. Provide a name for the Zone. This name will appear in the Create/Edit Door popup dialog in the drop-
•
down list boxes that reflect the available Zones.
Choose a Muster State. (Optional) To list all credential holders who entered this Zone (on the Events Page), choose the
•
'Inside' Muster Zone in the drop-down list box. To list all credential holders who exited this Zone, choose the 'Outside' Muster
Zone. If you are not concerned about movement in this Zone, select 'Unknown'.
After entering the configuration above, click Submit to create the Zone. The Zone will immediately be visible in the Content
•
Area, and will also be available when creating or modifying Doors.

4.6.12 Edit Zone

To modify a Zone name or its Muster attribute, select the Zone and click the Edit Zone Action. An Edit Zone popup dialog, similar
to the Create New Zone dialog, will open. Make the needed changes and then click Submit. Changing a Zone name or Muster state
does not affect the Door controller.

4.6.13 Delete Zone

To delete a Zone, click the Zone you want to delete and click the Delete Zone Action. A delete confirmation message box will
appear, and the Zone will be deleted after confirmation.
If you try to delete a Zone that has Doors bordering that Zone, an error message will appear with this information. First,
NOTE
assign the Doors to other Zones, then delete the Zone.
SECTION 4: USER INTERFACE
Intelli-M Access V4.0 User Manual
69