Hobby De Luxe Easy Operation Manual page 35

04-6
The rotating stanchions may not be
used as a jack
After changing the tyre, the wheel
screws must be examined (after a 50
km drive) to ensure that they are tight
enough (tighten if necessary).
Changing the wheel
•
Set the corresponding jack
pipe of the swinging lever group or on the
longitudinal beam in the area of the axle
attachmentsof the wheel to be changed.
•
On caravans with a double axle, always set
the jack onto the rear axle; a hydraulic jack
is recommended.
•
If the vehicle is parked on soft ground, lay
a stable reinforcement under jack
board).
•
Lift the vehicle until the wheel is 2 or 3 cm off
the ground.
• Reposition the ratchet jack
slant when you jack up the vehicle.
• Remove the wheel fastening screws and the
wheel.
•
Attach the spare tyre to the hub and adjust it.
•
Reattach the wheel screws and tighten them
lightly over the transversal.
*
•
Lower the jack and remove it.
•
Tighten the wheel fatening screws evenly
with the wheel wrench. The nominal value of
the attachment torque is 110 nm for steel rims
and 120 nm for aluminium rims.
•
Release the handbrake and reactivate the
stabilization system.
You should have a functional spare
tyre available at all times. Therefore,
have the spare tyre replaced without
delay.
*
!
*
onto the axle
*
(i.e., a
*
handle if it should
*