Battery Installation - Lectrosonics UCR100 Quick Start Manual

Battery Installation

Battery Installation Battery Installation
Use fresh alkaline or Use fresh alkaline or Use fresh alkaline or
lithium 9 Volt batteries. lithium 9 Volt batteries. lithium 9 Volt batteries.
In all cases, observe In all cases, observe In all cases, observe
large and small battery large and small battery large and small battery
contact openings inside contact openings inside contact openings inside
the unit and orient the the unit and orient the the unit and orient the
battery accordingly prior battery accordingly prior battery accordingly prior
to inserting in the battery to inserting in the battery to inserting in the battery
compartment. compartment. compartment.
After installing the battery, turn the After installing the battery, turn the After installing the battery, turn the
unit on and check to see that the unit on and check to see that the unit on and check to see that the
Power LED is brightly lit. Power LED is brightly lit. Power LED is brightly lit.
Important Note: Before using transmitters with Important Note: Before using transmitters with Important Note: Before using transmitters with
the UCR100 Receiver, make sure they are set to the UCR100 Receiver, make sure they are set to the UCR100 Receiver, make sure they are set to
100 Series Compatibility Mode. Refer to your 100 Series Compatibility Mode. Refer to your 100 Series Compatibility Mode. Refer to your
transmitter's Quick Start Guide for instructions transmitter's Quick Start Guide for instructions transmitter's Quick Start Guide for instructions
on how to change compatibility modes. on how to change compatibility modes. on how to change compatibility modes.
2
Push outward on door, then rotate Push outward on door, then rotate Push outward on door, then rotate
to open. to open. to open.
LECTROSONICS, INC.
Power LED Power LED Power LED