Related Manuals for Lectrosonics UCR110
Summary of Contents for Lectrosonics UCR110
- Page 1 UCR110 UHF MULTI-FREQUENCY COMPACT RECEIVER - EURO MODEL OPERATING INSTRUCTIONS and trouble-shooting guide LECTROSONICS, INC. Rio Rancho, NM 0885...
-
Page 2: Table Of Contents
Only the UCR110 Receiver is covered in this manual. The companion UM110 trans mitter is covered in a separate manual. The UCR110 Receiver will operate with any Lectrosonics UM110 Transmitter in the same frequency block. -
Page 3: General Technical Description
Compact Receiver GENERAL TECHNICAL DESCRIPTION The UCR110 Receiver is comprised of a number of functional subsystems as shown in Fig 1, Block Diagram, Fig 2, Control Panel and Fig 3, Side Panel GENERAL FEATURES The multi-frequency UCR110 FM Receiver is designed to operate with the Lectrosonics UM110 Transmitter and features microprocessor control of 256 frequencies of operation within each frequency block. -
Page 4: Safety Notes
It is normal and desirable that you see an occasional flicker of the 0 dB lamp in typical use. Figure 2 –20 UCR110 ON/OFF POWER SWITCH Control Panel Turns the receiver power as supplied by the internal 9 volt battery. -
Page 5: Side Panel Controls & Functions
The receiver and transmiter switches must be set to the same number/ letter combination for proper operation. To gain access to these switches, slide the access door sideways with a fingernail. Figure 3 - UCR110 Side Panel Rio Rancho, NM – USA... -
Page 6: Operating Instructions
If the output is too low, you may hear steady noise (hiss) along with the audio. The UCR110 output was designed to drive camera line level inputs but can operate into camera MIC inputs if the receiver output is reduced to prevent Automatic Limiting Control “pumping”... -
Page 7: Battery Instructions
Solid On Solid On Solid On Solid On Blinks 90% on, 10% off Blinks 50% on, 50% off Blinls 10% on, 90% off Off (Replace battery) Figure 5 - UCR110 Approximate Battery Life with Alkaline Battery Rio Rancho, NM – USA... -
Page 8: Troubleshooting
TROUBLESHOOTING Before going through the following chart, be sure that you have a good battery in the receiver. The POWER LED should glow brightly. SYMPTOM POSSIBLE CAUSE NO POWER LED 1) Receiver switch in “OFF” position 2) Dead or weak battery 3) Battery not installed 4) Battery installed backwards NO RF LED... -
Page 9: Specifications And Features
1996. A copy of the Declaration of Conformity may be requested from your dealer or by contacting the factory directly: Lectrosonics, Inc. Marketing Department 581 Laser Rd. NE, Rio Rancho, NM 87124 USA tel: 505-892-4501 fax: 505-892-6243 e-mail: marketing@lectrosonics.com Rio Rancho, NM – USA... -
Page 10: Service And Repair
This warranty does not apply to used or demonstrator equipment. Should any defect develop, Lectrosonics, Inc. will, at our option, repair or replace any defective parts without charge for either parts or labor. If Lectrosonics, Inc. cannot correct the defect in your equipment, it will be replaced at no charge with a similar new item.
Need help?
Do you have a question about the UCR110 and is the answer not in the manual?
Questions and answers