Dish Network HDTV DVR Satellite Receiver User Manual page 84

Chapter 10
Operating Other Devices
Press the PLUS side of the VOLUME button.
3
4 Press 0.
Press POUND (#). The TV button flashes three times.
5
To confirm the VOLUME buttons are operating the TV's volume control, press SAT and
then try adjusting the volume. The TV's volume should change.
Programming to Control a Second Satellite Receiver
If you have a second DISH satellite receiver installed, you can use this remote in AUX
mode to operate your other receiver in addition to operating this receiver. When you
program the remote to operate the other receiver, the remote sends out IR signals to the
receiver so the line of sight to the second receiver must be unobstructed. You can program
the remote control to operate any other DISH receiver, except where UHF is used, such as
TV2 on DISH receivers.
1
Display System Info
screen and note the
Remote Control Address
Turn on the other receiver and display the System Info screen as described in that user's
1
guide.
Write down the remote control address:
2 Press and hold AUX until all the other mode buttons light up, and then let go of the button.
AUX flashes.
Press the 3 button.
3
Use the NUMBER PAD to enter the address you wrote in step 1.
4
Press POUND (#). AUX blinks three times.
5
6 Press RECORD to ensure the address in the remote matches the address on the receiver.
76
3
Press the
2
3 button
AUX
Press and hold the
AUX Mode button until all
Mode buttons light up
(AUX flashes)
4
5
Press POUND
Enter remote
(AUX flashes
address from
three times)
Step 1
6
Press
RECORD