Dish Network HDTV DVR Satellite Receiver User Manual page 132

Reference
Troubleshooting Tables
Hearing A Program
What Is Happening
The receiver front panel power light is
on and there is a good picture on the
TV set, but you do not hear any
sound.
You hear a foreign language with a
program.
Caller ID
What Is Happening
Caller ID is not working.
112
Possible Reason
• You may have muted the
sound, or set the volume so
low that you cannot hear it.
• The audio connections may
not be properly connected.
• You have selected Dolby
Digital Only when there is no
Dolby Digital soundtrack.
You may have set the receiver to
select an alternate audio
language. The program may be
in a foreign language.
Possible Reason
• You do not have Caller ID
service from your local phone
company.
• Your phone line is not
connected to the phone jack
on the back of the receiver.
• You do not have the Caller ID
option enabled.
What to Do
• Check the volume level on the TV or
audio device. Turn off the mute or
turn up the volume, as required.
• Check the audio connectors and
cables from the receiver to the TV or
the sound system.
• Check the TV speakers or the sound
system.
• In the Dolby Digital menu, select
Dolby Digital/PCM for the audio
output. If your decoder/amplifier will
not accept Linear PCM digital input,
use the analog connections instead.
Press the MENU button on your remote.
From the Main Menu, select
Preferences, then Alternate Audio, and
choose the language that you prefer.
What to Do
• Verify that Caller ID is a service
provided by your local phone
company.
• Verify that you have connected the
phone line to the phone jack on the
back of the receiver.
• Press the MENU button on your
remote. From the Main Menu, select
System Setup, then Installation, and
then Caller ID. Select the Enable
Caller ID option.