Les Foyers Don-Bar 9000 Installation, Operation And Maintenance Manual page 2

The installation shall meet the requirements of CAN/CSA B-365 - Installation
code for solid-fuel-burning appliances and equipment.
Don-Bar fireplaces are not designed to be connected to air-ventilated
factory-built chimneys (chimneys without insulation).
The ceiling support (standard or cathedral) is universal and used with all the
fireplaces mentioned in this manual. The installation can be done in two
practical steps:
If you are not sure
maximum clearances from combustible materials (Pages 6 and 17 to 21)
For simplicity, the Model 9000 is the only type illustrated in the drawings.
Installation of other models is similar.
A gas burner (propane or natural gas) with ceramic logs can also be installed.
The burner and its accessories must be certified by the concerned authorities
and meet the local codes and regulations where the fireplace will be installed.
CAUTION: The painted finish of the cathedral and regular ceiling
supports and the hood must remain visible to the eye. Because of
dangers of fire, these elements should not be covered with finishing
materials other than those supplied and approved by Don-Bar.
THE 9000 SERIES FIREPLACES MEET THE REQUIREMENTS OF:
Wood : ULC S627 in Canada, UL 1482 in USA
Gas:
EPA:
REV. 2014-10
1) The chimney and its ceiling support can be installed during the
the construction phase; the fireplace is not required for this step.
2) Then, you can wait until the work is complete to select the fireplace
model and proceed to final installation. This protects the fireplace
from being damaged and there is no hassle of protecting the fireplace
during construction.
which fireplace you'll be choosing, it's best to allow
CSA 2.22 in Canada, ANSI Z21.50 in USA
Certified EPA Exempt
IMPORTANT
Page 2