Installation of the optional structural tubular frame for
the pivot doors (9000, 9120)
pivot
Handle with
tongue latch
Opening panes
Glass door assembly
DRAWING 13
13. Installation of the optional hood
decorative panels (9000, 9200, 9800)
13.1
Installation of the decorative hood
panels: The installation of the decorative panels
must be done in two steps. First, the sub-panels
must be fixed directly on the fireplace hood with
metal screws. Next, the decorative panels are
simply laid in place over the sub-panels without
any fastening.
REV. 2014-10
Upper fixing bolt
pivot
support
Fireplace table
Page 14
Retaining square
to be laid down on
the hood interior fold
for a sandwich
hold
13.2 Sub-panel fixation:
diameter holes in the fireplace hood where sub-
panel fixations are located (if not already done at
shop). Adjust the sub-panels to let a regular 1"
(25 mm) free space between each panel. Fix the
sub-panels in place with 3/8" (10 mm) long
metal screws.
13.3 Decorative panels installation: Set the
decorative panels in place handling them with
care to prevent damages. Decorative panels are
simply laid down in place over the sub-panels.
No fastening is required.
Fastener keeping
the doors closed
Pivot
Spacing washers
piled up to the
height of the
decorative finish
laid on the table
Sliding frame
filling the joint
between the
doors and the table
(for retro-fit installations
only)
Lower fixing bolt
inserted from
under the table
(Note: Bolt not
required for
retro-fit installations)
Drill 1/8" (3 mm)