Makita 2012NB Instruction Manual page 11

Install the other blade as described above. Rotate the drum slowly while pressing the
lock plate to make sure there is nothing abnormal. Then install the chip cover and the
side cover.
CAUTION:
*Do not tighten the blade installation bolts without the blade locating lug of the set
plate correctly resting in the groove of the blade. This may cause damage to the blade
and potential injury to the operator.
Do
not turn the tool on with the chip cover removed.
Planer stand (optional accessory)
Place the stays on
a
level location and
assemble the legs inside. Secure with the
cap square neck bolts, spring washers and
hex nuts, then attach the rubber caps to the
ends of the legs.
Now set the planer on the top of the
assembled stand and secure with the four
hex bolts, flat washers and hex nuts.
NOTE:
Insert the hex bolts the through the holes
from the reverse side
of
the stand and
secure them with the flat washers and hex
nuts. If you insert the hex bolts from above
the planer base, the hex bolts cannot be
firmly secured.
The planer stand should be bolted with the
four bolts to the floor using the bolt holes
provided in the legs.
Hex
bolt
Hex bolt
11