Cisco Linksys WET610N Quick Installation Manual page 16

Troubleshooting
The Bridge cannot be accessed.
Follow these instructions:
1 . Reset the Bridge to its factory
default settings . Using an object
with a small tip, such as a pen,
press and hold the Bridge's Reset
button for approximately five
seconds . (The Reset button is
located between the Ethernet
and Power ports .)
2 . On the TV, select RETURN to restart the Network Setup process .
No wireless networks are
detected by the Bridge.
Follow these instructions until
your problem is solved:
• Select Back to repeat the
search for wireless networks .
Repeat the search until your
wireless network is detected .
Select Manual Entry to enter the name of your wireless network (also
•
called an SSID) . Then select Continue . Proceed to the instructions in the
Scan (Manual Setup) section, step C, on page 8 .
NOTE: For more information about how to install the Bridge for
use with the Sony BRAVIA TV, refer to the Online Reference Book
for your TV, and then search for the Network Setup section . For
other information about the Bridge, refer to the User Guide on
the CD included with the Bridge .
12 Wireless-N Ethernet Bridge with Dual-Band
WET610N