Troubleshooting - Cisco Linksys WET610N Quick Installation Manual

WET610N

Troubleshooting

If you encounter any problems during the installation process, please try
the solutions for your problem .
The Bridge is not found.
1 . Follow these instructions until
your problem is solved:
• Make sure the Bridge is
powered on .
Make sure the network
•
cable is securely
connected to the Bridge
and TV .
Disconnect the power adapter from the Bridge . Wait five seconds .
•
Then connect the power adapter to the Bridge .
Reset the Bridge to its factory default settings . Using an object with a
•
small tip, such as a pen, press and hold the Bridge's Reset button for
approximately five seconds . (The Reset button is located between
the Ethernet and Power ports .)
2 . On the TV, select RETURN to try again .
The TV has lost its connection
to the Bridge.
1 . Follow these instructions until
your problem is solved:
Make sure the Bridge is
•
powered on .
Make sure the network cable is securely connected to the Bridge
•
and TV .
Disconnect the power adapter from the Bridge . Wait five seconds .
•
Then connect the power adapter to the Bridge .
Reset the Bridge to its factory default settings . Using an object with a
•
small tip, such as a pen, press and hold the Bridge's Reset button for
approximately five seconds . (The Reset button is located between
the Ethernet and Power ports .)
2 . On the TV, select RETURN to restart the Network Setup process .
Wireless-N Ethernet Bridge with Dual-Band
Troubleshooting
11