Important - Sagitter ARROW300B User Manual

4.1Important:

Th e manufactur er w ill n ot acce pt liabili ty f or an y resultin g damage d cause d b y
th e non-observanc e of th is manu a l o r an y unauthorize d modificatio n t o th e
device.
Pleas e consid er th at damage s cause d b y manu a l modification s to th e device
a re n ot subjecte d to warranty.
Nev er l et th e power-co rd com e in t o connectin g wi th oth er cable s ! Hand l e the
pow er co rd an d a ll connection s wi th th e main s b y particul ar caution!
Mak e su re th at th e availab le voltag e is n ot high er tha n state d o n th e re ar panel.
Always plug in the power socket. Make sure that the power-switch is set to
off-position before you connect the device to the mains. The power plug has to be
accessable after installing the device.
Make sure that the power-cord is never crimped or damaged by sharp edges.
Check the device and the power-cord from time to time.
Always disconnect from the mains, when the device is not in use or before
cleaning it.
Only handle the power-cord by the plug. Never pull out the plug by tugging the
power cord.
This device falls under protection class I. Therefore it is essential to connect the
yellow/green conductor to earth.
The electric connection, repairs and servicing must be carried out by a
qualified employee.
Do not connect this device to a dimmer pack.
Do not switch the fixture on and off in short interval since this would reduce the
lamp's life.
During the initial start-up some smoke or smell may arise. This is a normal
process and does not mean that the device is defective.
Do not touch the device's housing by bare hands during its operation(housing
becomes hot)!
For replacement use lamps and fuses of same type and rating only.
Avoiding looking directly into the light source
CAUTION! EYEDAMAGES!
(Meant especially for epileptics)!
7