Wind Calibration - Raymarine Remote display Owner's Manual

4.3

Wind Calibration

Both Wind Speed and Direction can be calibrated to ensure that
readings from the Wind Transmitter are displayed accurately.
Wind Angle Offset
Motor the vessel directly into the wind.
Press and hold the
Press the
Press the
Press the
Press the
Press the
parameter.
number of degrees of offset entered.
Press the
Press and hold the
operation.
Wind Speed Correction
Note: The Wind Speed reading is factory calibrated to display correctly
and should not be altered unless external factors are thought to be
causing incorrect readings. Correction should only be carried out if a
known correct Wind Speed is available.
Press and hold the
Press the
Press the
Press the
Press the
Press the
parameter.
percentage correction factor entered.
Press the
Press and hold the
operation.
www.raymarine.com
button to enter Setup.
button repeatedly to select the Sensors chapter.
button to enter the Sensors chapter.
button repeatedly to select the Wind page.
button to enter the Wind page.
button repeatedly to select the WIND +/- o (Wind angle)
Press the
value will flash.
Press the and
displayed (in small type) to 000. The display will indicate the
button to exit Edit Mode.
button to enter Setup.
button repeatedly to select the Sensors chapter.
button to enter the Sensors chapter.
button repeatedly to select the Wind page.
button to enter the Wind page.
button repeatedly to select the WIND +/- % (Wind speed)
Press the
value will flash.
Press the
value to the required percentage. The display will indicate the
button to exit Edit Mode.
button to enter Edit Mode, the parameter
buttons to change the wind angle
button to exit Setup and return to normal
button to enter Edit Mode, the parameter
and buttons to change the displayed
button to exit Setup and return to normal
Seatrial and Calibration
33