Section 2: Getting Started; Battery Installation And Start Up - Garmin eTrex Vista C Owner's Manual

Installing the Batteries
The eTrex Vista C operates on two "AA" batteries (not included),
which are located in the back of the unit. Alkaline or NiMH batteries
may be used (see page 56 for setting the battery type). Stored data will
not be lost when batteries are removed.
To install batteries:
1. Remove the battery cover from the
back of the unit by turning the
D-Ring 1/4 turn counter-clockwise
and pulling out.
2. Insert the batteries, observing the
proper polarity. A polarity diagram
can be found molded into
the battery compartment.
3. Reinstall the battery cover by
inserting the bottom slot over the
tab at the base of the unit and
reinserting the locking pin in the
back of the unit. Turn the D-Ring
1/4 turn clockwise to lock in place.
Locking
Pin Slot
Battery Compartment
eTrex Vista C
Getting Started
Battery Installation and
Start Up
Important Note
When replacing batteries, use only new or fully
charged batteries. Do not mix Alkaline and NiMH bat-
teries. Rechargeable batteries may typically display less
capacity than disposable batteries.
Remove the batteries from the unit if you don't plan to
use it for several months. Storing batteries in the unit
for prolonged periods of time may result in leakage
and damage to the battery compartment.
Follow the manufacturer's instructions for proper care
and disposal of used batteries. Do not incinerate used
batteries, as internal materials may ignite with explosive
violence.
Extensive use of backlighting and/or WAAS as well as
key beep tones will signifi cantly reduce battery life.
To set backlighting intensity and timeout, see page 56.
To disable WAAS, see page 56.
To mute the beep tones, see page 57.
1