Power-On Self-Test - Mitsubishi Apricot MS Series Owner's Handbook Manual

OWNER'S HANDBOOK
Getting help in BIOS Setup
You can at any time get general help about the
control keys by pressing the
The help window on the right-hand side of each
menu displays help text for the currently-selected
field. It changes as you move the cursor from one
field to another.

Power-on self-test

Recoverable POST errors
Whenever a recoverable (non-terminal) error occurs
during POST, the BIOS displays an error message
describing the problem (the most usual are described
below). After some messages, you may be prompted
to Press <F1> to resume, <F2> to enter Setup or just
Press <F2> to enter Setup.
In general, you should respond to these errors as
follows:
♦
Shut down the computer, wait 20 to 30
seconds, and then turn it on again to see if the
problem is still reported.
7 / 4 B I O S S e t u p & P O S T
1 key.
F
Reserving ISA legacy resources
To reserve interrupts and upper memory block
(UMB) regions for ISA expansion cards, go to the
Advanced menu, select PCI Configuration, then
select PCI/PNP ISA IRQ Resource Exclusion or
PCI/PNP ISA UMB Region Exclusion as required.
♦
Check that all external cables are securely
connected.
♦
Try running the BIOS Setup utility to
reconfigure the system. If the computer won't
start after you make changes in BIOS Setup, try
restoring the original values.
♦
Open up the system unit and check that all
internal signal and power cables are securely
connected.
♦
If the problem persists, contact your supplier or
authorised maintainer.