Vauxhall Corsa 2007 Owner's Manual page 150

146 Driving and operation
Stopping the vehicle
In Automatic or Manual mode, when the
vehicle has stopped first gear (with Winter
programme engaged, second gear) is
engaged automatically and the clutch
released. In R reverse remains engaged.
A warning buzzer sounds when the driver's
door is opened if the engine is running, a
gear is engaged and the footbrake is not
depressed. The vehicle creeps if the
handbrake is not applied. Move the
selector lever to N and apply the
handbrake.
When stopping on gradients, engage the
handbrake or depress the footbrake. To
prevent overheating of the clutch, do not
increase engine speed to ensure smooth
idling when in gear.
To prevent damage to the Easytronic, the
clutch is automatically engaged at very
high clutch temperatures.
Switch off engine if stopping for a lengthy
period, e.g. in traffic jams or at level
crossings.
Ofrecido por www.electromanuales.com
Vehicle storage
Before leaving the vehicle:
z apply handbrake,
z remove ignition key.
The most recently engaged gear (indicator
in transmission display) remains engaged.
With N, no gear is engaged.
When the ignition is switched off the
Easytronic no longer responds to
movement of the selector lever.
Lock the vehicle. Otherwise the battery
may become discharged if the vehicle is
parked for long periods.
If the handbrake has not been applied,
control indicator R flashes for a few
seconds after the ignition is switched off.
With the engine off and the handbrake not
applied, when the driver's door is opened a
warning buzzer sounds and the control
indicator R flashes; switch on ignition,
engage gear, switch off ignition and apply
handbrake.
Fault
Control indicator A illuminates in the
event of a fault in the Easytronic system. In
the event of serious faults, "F" also appears
in the transmission display.
It is possible to continue driving if only
control indicator A illuminates. Manual
mode can then no longer be selected.
If "F" also appears in the transmission
display, continued driving is not possible.
Have cause of fault remedied by a
workshop. The system's integrated self
diagnostics allow faults to be quickly
remedied.