Specifications; Battery Replacement - GE 60-362 Installation Instructions

For example, during a sensor test you normally expect to hear up
to eight data rounds. Because the power saving feature is on, you
may only hear up to four data rounds.
To ensure a sensor is within range of a panel, leave the sensor in
the closed (non-alarm) condition for five minutes prior to trip-
ping it. This allows the sensor to disengage the power-saving
feature and provides for more accurate test results.

Battery Replacement

When the system indicates a low sensor battery, immediately
replace the battery. Use only exact replacement batteries (see

Specifications).

1. Remove sensor cover.
2. Remove battery and dispose as required by local laws.
3. Insert replacement battery. Observe polarity (see Figure 4).
4. Perform sensor test.
Figure 4. Observing Battery Polarity
Positive Terminal
GE Security
1275 Red Fox Road
Arden Hills, MN 55112
www.gesecurity.com
Specifications
Model No. 60-362: Door/Window Sensor
60-641: Long Life Door/Window Sensor
Compatibility All GE Security 319.5 MHz Learn Mode panels
Power Source 60-362: 1/2 AA 3.6V Saft or Tekcell Lithium Battery
60-641: AA 3.6V Lithium Battery
Storage Temperature -30° to 140°F (-34° to 60°C)
Operating Temperature 10° to 120°F (-12° to 49°C)
Maximum Humidity 90%, non-condensing
Transmit Range Minimum of 500 feet in open-air
UL Listings UL 1023 – Household Burglar Alarm Units
Notices
This device complies with FCC Rules Part 15. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference that may be received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by GE Security can
void the user's authority to operate the equipment.
FCC ID: B4Z-503A-DWS
Technical Support
T: 800.777.2624
F: 651.779.4890
and Systems
3