Record Stream - Okina HDRS-04-1U User Manual

4.3.2 Record stream

Step1: enter into system configurationrecord configurationrecord bit rate; refer to Fig 4-10:
Step2: setup rate, resolution, quality, encode and max bit stream
Step3: user can setup all channels with same parameters, tick off "All", then to do relevant setup.
Step4: click "default" button to resort default setting; click "apply" button to save the setting; click "exit" button
to exit current interface.
Note: if the rate value set is over high the maximum resources of the device, the value will be adjusted
automatically.
Definitions and descriptions of Record stream:
Parameter
Rate
Resolution
Quality
Encode
Max bit stream
4.3.3 Time
Step1: enter into system configurationrecord configuration time; refer to Fig 4-12:
Pre-alarm record time: the record time before event happen i.e. record time before motion detection or sensor
alarm is triggered.
Post-alarm record: set the post recording time after the alarm is finished, five options: 10s, 15s, 20s, 30s and 60s.
DV-8_HDRS-04-1U / DV-9_HDRS-08-2U / DV-10_HDRS-16-2U User's Manual
16CH
Fig 4-10 record configuration-record bit rate
Range from: 1-30（NTSC）1-25(PAL)
Support CIF and D1
The quality of recorded images. The higher the value is, the
clearer the recorded image is. Six options: lowest, lower,
low, medium, higher and highest.
VBR and CBR
Range from: 64 Kbps、128 Kbps、256 Kbps、512 Kbps、
768 Kbps、1Mbps、2 Mbps
Fig 4-12 record configuration-time
16
Meaning
R201304-V10