I2M Chrome User Manual page 26

configurable. Choosing the "single RPM LED", only one LED will be on. For a low number of RPMs
the LED turned on will be the one on the left, then, it will move on the right step by step when the
RPMs increase.
Setting the "overrun flashing" function all the LEDs set as RPMs will start to flash when the higher
threshold is exceed, this function can be used as an overrun or gear alarm.
Use the configuration lines on the bottom of the screen to set the alarms for each LED (if "RPM"
mode is selected the upper LEDs cannot be selected). The "LED alarm" function allows to choose
the LED that will be highlighted on the screen. The channel identifies the analog or digital channel
coupled with that alarm LED. The "turn on direction" points out if the LED has to be turned on when
the channel value is greater or lower than the threshold value. Using the "auto" function the system
shows the user how to configure the threshold. If the chosen channel is a tire temperature sensor it
is possible to set the "temperature" option in the "turn on direction" option so that the threshold can
be directly shown in degrees. In this case, if the temperature is lower than the set degree value the
LED will turn on.
19. Options
mode instead of turning it off, this way the time needed by Chrome to power on from the standby
mode is reduced to zero. When the system is in standby mode it absorbs about 150mA, therefore
the system can stay in standby mode for no more than 10-12 hours. In order to preserve the
battery charge, use the "standby time after shutdown" option to choose the maximum standby
mode time. After this time the system will be automatically turned off.
The "Finish detection" option allows to enable the crossing of the finish line function, not via the
GPS but via the signal from an external transponder. To read the external transponder the
appropriate interface for the transponder has to be connected.
The "Options" menu
information about the system. It is possible
to see the installed firmware version,
choose the language (if more than one
language is installed), choose the display
brightness and the time zone.
Particular attention must be paid to the
"standby time after shutdown" option. The
system requires about 15-20 seconds to
complete the power-on. This time can be
reduced by switching Chrome in standby
shows general