I2M Chrome User Manual page 12

Installing a Plug & Play kit is extremely simple, it is sufficient to connect the additional board and
load the settings related to your bike.
Additional board
The additional board is typically a simple board to adapt the wiring of Chrome and the one of the
original dashboard. In the cases listed below, the additional board also includes other connections:
-­‐
Yamaha: the board also includes a male/female connector that has to be connected in
series to the original speed sensor connector and a blue cable that has to be connected to
the water temperature sensor. The latter comprises two wires, one connected to the
ground, connect the blue cable to the other terminal (it is necessary to identify the wire
connected to the ground with a tester).
-­‐
Suzuki: the board also includes a blue wire that has to be connected to the temperature
sensor water of the bike. The latter comprises two wires, one connected to the ground,
connect the blue cable to the other terminal (it is necessary to identify the wire connected to
the ground with a tester).
-­‐
Ducati 1198: the board also provides a CAN BUS connection, the CAN BUS board
connector (2-pin AMP) must be connected to the corresponding CAN BUS pins in the 20-
pin Chrome connector.
-­‐
KAWASAKI ZX10R >2010: the board also provides a CAN BUS connection, the CAN BUS
board connector (2-pin AMP) must be connected to the corresponding CAN BUS pins in the
20-pin Chrome connector.
-­‐
BMW S1000RR <2011: the Plug & Play harness for BMW is different from the previous
ones and provides an additional wiring. The additional wiring has to be connected to the
DWA connector in the motorcycle tail and to the fuel level sensor under the tank (replacing
the original). The other side of the Plug & Play harness has to be connected to Chrome to
the corresponding CAN BUS pins in the 20-pin Chrome connector.
Therefore it is necessary to make a jumper in the white connector pin 1 and 2 (see pic a) to
enable the power on. In order to enable the ABS/TC button on the left block, which is the
only one working in "RACE" configuration, it is necessary to restore its ground connection
making a second jumper between the white connector pin 6 and the black connector pin 1
(see pic b).
(a)
An explanatory video can be seen at this link:
http://www.youtube.com/watch?v=E2_cQmQnBbY
(b)