Table of Contents
Advertisement
Automatic configuration
We recommend that you carry out a manual configuration of your terminal. The automatic
configuration of the local network settings may be considered, if your local network features a DHCP
or BOOTP server that can dynamically assign addresses to the peripheral devices present on the LAN.
To automatically configure the local network settings:
+
Choose
AUTOMATIC
or BOOTP server that can assign it its settings dynamically (the message
displayed).
+
Once the message
and Gateway address. If these are missing, you should carry out a manual configuration
(see below).
Manual configuration
To configure your terminal manually, you should obtain the usual information used to set a peripheral
device (IP address, sub-network mask, network and gateway address).
To configure the local network setting manually:
+
Choose
MANUAL
IP address
+
Enter the IP address of your terminal and press OK to confirm.
Sub-network mask
+
Enter the sub-network mask of your terminal and press OK to confirm.
Gateway address
+
Enter the IP address of the network gateway and press OK to confirm.
L
OCAL NETWORK SETTINGS
2531 OK - SETUP / NETWORKS / LOCAL NETWORK / CONFIGURATION
and press OK to confirm. The terminal scans the local network for a DHCP
has disappeared, check for the IP Address, Sub-network mask
SELF-CONF
2531 OK - SETUP / NETWORKS / LOCAL NETWORK / CONFIGURATION
and press OK to confirm.
2532 OK - SETUP / NETWORKS / LOCAL NETWORK / IP ADRESSE
2533 OK - SETUP / NETWORKS / LOCAL NETWORK / SUBNET MASK.
2534 OK - SETUP / NETWORKS / LOCAL NETWORK / GATEWAY
3-12
Setting your machine
is
SELF-CONF
Advertisement
Table of Contents
