Adjustments; Focusing The Beam; Shaping The Beam; The Yoke - Strong Neeva User Manual

Adjustments

Focusing the beam

To focus the beam, loosen the two beam focus knobs located on the top and bottom of the
lens tube. Slide the lens tube forward or backward to achieve a sharp focus.
Note: Due to the unique nature of the Neeva LED Profile a soft focus is not desirable.
Best results are achieved by using your choice of diffusion materials when you want to
achieve a soft focus effect.
After you have the fixture in focus, tighten the beam focus knobs.

Shaping the beam

The beam can be shaped using the four built-in shutters or via the drop in pattern holder.
The pattern holder slot in just in front of the shutters. The supplied patter holder is a B-Size
device and hold 2.5" and 2.75" patterns.
Note: Because the Neeva has a 2.125 inch aperture it is recommended that the image
area of a pattern be limited to 2 inches or less for best results.
A drop-in slot is located in front of the pattern holder slot that is designed for optional iris
or pattern spinning devices. A small cover is installed to prevent light leaks when an
accessory is not installed. Loosen the two screws that hold the cover (do not remove) and
slide the cover forward so that the accessory can be installed. Fit the cover appropriately
to the accessory and tighten the screws. When installing an accessory device in this slot
make sure to follow the accessory manufactures instructions.

The Yoke

Adjusting Yoke Position

The Neeva provide for two yoke configurations; the standard use position and a low
clearance position. To change the fixture from its standard position, remove the yoke
locking knobs, screws, washers, and hex bolts from either side of the fixture. Move the
yoke to the alternate position and reinstall the hardware.
Add figure 3 here showing yoke configurations
9