Programming; End Point Adjustments; Channel 3 Multi-Position - Tactic TTX300 Instruction Manual

PROGRAMMING

Several of the TTX300 features are adjusted electronically by entering the
programming mode. To enter the programming mode, follow these steps:
1. With the transmitter turned off, turn steering wheel full right, pull the trigger
to the full throttle position and turn the transmitter's power switch to ON. The
LED will fl ash to confi rm when performed correctly.
2. Release the wheel and trigger at this time.

End Point Adjustments

Steering:
1. Enter programming mode.
2. LEFT EPA: Turn wheel FULL
COUNTERCLOCKWISE, use 3rd
channel push buttons to adjust.
3. RIGHT EPA: Turn wheel FULL
CLOCKWISE, use 3rd channel
push buttons to adjust.
Channel 3:
The TTX300 3rd channel is programmable and offers a wide variety of options
to suit many applications. Selecting the number of positions and end point
adjustments are performed at the same time. To change the function and set
end point adjustments for CH3, follow these steps:
REVERSE: Press and hold the bottom push button and power ON
transmitter. The LED will fl ash one time. After 3 seconds, the LED will fl ash
two times when performed correctly. Release the bottom push button.
MULTI-POSITION: The TTX300 3rd channel can be programmed to
function as 2 position, 3 position, 4 position or proportional control switch.
Selecting each position and end points for each position are performed
simultaneously. The default position of CH3 is 2 position. To change the
function of CH3, follow these steps:
1. Enter programming mode: Press and hold the top push button, power
ON transmitter. Continue to hold until the LED fl ashes fi ve times.
Release the top push button.
2. Use CH3 push buttons to adjust CH3
accessory/servo to desired 1st position.
Turn steering wheel clockwise (right) to
confi rm position 1. The LED will fl ash
one time to confi rm position 1 has been
saved. Note: Press and holding CH3
push buttons will adjust rapidly. Press
and release will fi nely adjust positions.
Throttle:
1. Enter programming mode.
2. THROTTLE EPA: Pull trigger to the
FULL THROTTLE position, use 3rd
channel push buttons to adjust.
3. BRAKE EPA: Push trigger to the
FULL BRAKE position, use 3rd
channel push buttons to adjust.
First use
CH3 buttons
to set.
4
Then turn wheel
clockwise
to confirm.