Operation For A Double Number Of Channels; Programming The Timer For A Double Number Of Channels - Conrad Electronic FS20 S4A-2 Operating Instructions Manual

• Operation for a double number of channels

A different channel is assigned to each button. The control indicator briefly lights up to
signal that a command has been transmitted.
Switching
Pressing a button quickly (for less than 0.4 seconds) sends a switching command.
Whenever a button is pressed the addressed receiver changes its switch state from 'OFF'
to 'ON' or from 'ON' to 'OFF'.
Dimming
Pressing a button for longer than 0.4 seconds sends a dimming up or a dimming down
command until the button is released (lamp is dimmed up to its maximum and then dimmed
down to its minimum etc.).
Here too, the dimming state (up or down) changes whenever a button is pressed. If, for
example, the last command caused a lamp to dim up, then pressing the button again would
result in the lamp dimming down.

• Programming the timer for a double number of channels

In order to program a receiver's timer function, proceed as follows:
Press the button that is assigned to the receiver (keep the button pressed!). Press the
button next to it for one to five seconds (1 sec to 5 sec) and then release it. Only afterwards
should you release the button that you pressed first.

This procedure is used to start as well as to stop the programming of the timer.
For information on how to program the timer, see the instructions in the
receiver's user manual.
13