Table of Contents
Advertisement
The transmitters' channels are already set to the same addresses and only need to be changed
if required, for example, if you are using an extensive FS20 wireless control system with
numerous receivers/transmitters.
See the relevant example in section 12. d).
c) Timer functions
In order to program a receiver's timer function you must simultaneously press the button
combination (e.g., buttons '
for one to five seconds (1 sec to 5 sec) on the wall-mounted transmitter.
This command is used to start as well as to stop the programming of the timer.
For information on how to program the timer, see the instructions in the
receiver's user manual.
d) Double number of channels
The wall-mounted transmitter can be used as a 2-channel wall-mounted transmitter (default
setting: two buttons are assigned to each channel, for example, buttons '
assigned to channel 1) as well as a 4-channel wall-mounted transmitter (each channel now
only has a single button assigned to it and no button combination, e.g., button '
1, button '
2
' for channel 2 etc.).
• Switching between a single and double number of channels
You set a double number of channels (four individual switching channels) by simultane-
ously pressing the buttons '
seconds. The control indicator/LED lights up briefly to confirm the setting.
You set a single number of channels (four switching channels, each with two buttons) by
simultaneously pressing the buttons '
indicator/LED lights up briefly to confirm the setting.
Please note:
Different operating and programming instructions apply when a double number
of channels has been set!
12
1
2
' and '
' for channel 1) that have been assigned to the receiver
2
3
' and '
' (see section 8. Control panel) for at least five
1
' and '
4
' for at least five seconds. The control
1
2
' and '
' are
1
', for channel
Advertisement
Table of Contents
