Table of Contents
Advertisement
9. Installation
You can mount the wall-mounted transmitter either by simply sticking its casing to a suitable
surface or by screwing it on using the available mounting holes.
The places in the casing that are marked with 'TOP' must always point upwards
(the small additional circuit board in the casing lies beneath).
a) Adhesive mounting
• Use the supplied double-sided adhesive tape, for example, to mount the device to a wall.
• Carefully clean both surfaces where the adhesive is to be applied (wall-mounted transmit-
ter and mounting surface).
Fatty residues (also fingerprints), moisture, lubricating films and silicon residue, in particu-
lar, can prevent the device from adhering properly.
• Remove the protective strip from the adhesive tape and stick it to the back of the wall-
mounted transmitter. Press on the adhesive tape firmly and evenly in order to ensure firm
a adherence.
• Remove the second protective film and place the wall-mounted transmitter onto the desired
attachment surface, keeping it straight.
You can ensure that the wall-mounted transmitter is extra securely fixed by
firmly pressing on the base cover alone (first remove the front panel and
unscrew the circuit board).
Make sure that the device is straight/level as it not possible to make
mounting adjustments afterwards!
b) Screw fixing
• Open the casing by carefully lifting the front cover on the side opening slots using a one
penny coin, for example.
• Place the lower part onto the desired mounting location, keeping it straight, and use a
pencil, for example to mark the drilling holes through the mounting holes of the casing.
9
Advertisement
Table of Contents
