Table of Contents
Advertisement
10. Operation
Please note:
In the delivery state the components of the FS20 wireless control system (e.g.,
a wireless switch socket) do not respond to remote control commands from the
wall-mounted transmitter. They must first be addressed according to the
instructions provided in the respective device's user manual.
Only afterwards can the functions be controlled.
a) Basic functions
Buttons are pressed quickly (switch) or for longer than 0.4 seconds (dim), as required.
The ON command (or dim up) is globally allocated to the respective right
button of a channel (buttons '
down) is allocated to the associated left button ('
The control indicator/LED briefly lights up to signal that a command has been transmitted.
Now you can program and operate the basic functions of the FS20 components.
Please also read the following sections, if you require an extended system with
several components or you wish to use the additional functions.
b) Using several transmitters
In the delivery state each transmitter in the FS20 wireless control system has its own, randomly
set house code.
If you want to jointly control one or several receivers via different transmitters,
you first need to coordinate the transmitters' house codes. The same house
code must be set for each transmitter.
Make sure you coordinate or set this shared house code for all the
transmitters before programming the receivers for the first time, as the
associated house code is also sent to the receiver during this procedure.
2
4
' and '
'), while the OFF command (or dim
1
' and '
3
').
11
Advertisement
Table of Contents
