Table of Contents
Advertisement
12. Integrating the 'FS20 S4A-2' wall-mounted
transmitter into the address system
The house code, an address group and a subaddress are used for coding the wall-mounted
transmitter and its switching channels. You can also use special address group assignments
to program the wall-mounted transmitter as a local or global master.
Only the '
house code, the two-digit address groups and the two-digit subaddresses (see
the figure in section '8. Control Panel').
This addressing makes 225 single addresses, 15 function groups, 15 local master addresses
and 1 global master address available within each house code to the wall-mounted transmitter.
a) Setting the house code
Once the batteries have been inserted for the first time, the wall-mounted transmitter selects
a random house code.
If required, this house code can be changed as follows:
1
• Keep the '
' and '
until the control indicator/LED flashes every second.
1
• Now use the '
This must be identical for all the remote control transmitters in the FS20 wireless control
system (as a precaution, make a note of this code and keep it safe).
Example: 23141342 (1= button '
• The programming mode ends automatically once you have entered the eighth digit. The
control indicator/LED goes out.
b) Setting the addresses
A channel's address comprises a two-digit address group and a two-digit subaddress (for
example, 1131, address group 11, subaddress 31).
The address group '11' is factory set for all channels.
If several transmitters are to be operated at the same time and control different receivers, then
different addresses need to be set on the transmitters.
16
1
', '
2
', '
3
3
' buttons on the wall-mounted transmitter pressed for five seconds
2
3
4
', '
', '
' and '
1
' and '
4
' buttons are used for entering the eight-digit
' buttons to enter your system's eight-digit house code.
2
', 2= button '
', 3= button '
3
4
', 4= button '
')
Advertisement
Table of Contents
