Table of Contents
Advertisement
7 Remove one screw (S13) in the ground.
Note: Be careful with the wiring of the ground cable when
reassembling.
8 While holding the hooks in the inlet from both sides, unhook
them from the back panel.
9 Remove one screw (S3) and then the noise prevention panel.
This removes the back panel from the filter unit.
Removing the sub key unit
1 Remove the tape, four screws (S2), and then the sub key unit.
Tape
— 22 —
Screw (S13)
Hooks
Screw (S3)
Hide quick links:
Advertisement
Table of Contents
