Shure AXT900 User Manual page 12

Rack mount charging station
Hide thumbs Also See for AXT900:
Table of Contents

Advertisement

Specifications- AXT900 Rack Charger
Battery Type
Up to 8 rechargeable Li-Ion batteries
(AXT910/920/920SL)
Charge Time
50%=1 hour; 100%=3 hours
Charging Module
Up to 4 charging modules (AXT901 or AXT902) in any
Type
combination
Operating
-18°C (0°F) to 63°C (145°F)
Temperature
Range
Battery Charging
0°C (32°F) to 60°C (140°F)
Temperature
Range
Storage
-29°C (-20°F) to 74°C (165°F)
Temperature
Range
Dimensions
44 mm x 483 mm x 366 mm (1.7 in. x 19.0 in. x 14.4 in.),
H x W x D
Weight
4.4 kg (9.8 lbs), without batteries or charging modules
Housing
Steel; Extruded aluminum
Power
100 to 240 V AC, 50-60 Hz
Requirements
Current Drain
2.5 A RMS (referenced at 120 V AC)
Networking
Network Interface
Dual Port Ethernet 10/100
Network
DHCP or Manual IP address
Addressing
Capability
Certifications
Conforms to electrical safety requirements based on IEC 60065.
c UL us listed by Underwriters Laboratories, Inc.
Authorized under the verification provision of FCC Part 15B.
This Class B digital apparatus complies with Canadian ICES-003. Cet appareil nu-
mérique de la classe B est conforme à la norme NMB-003 du Canada.
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation of this device is subject to the following two conditions: (1) this device
may not cause interference, and (2) this device must accept any interference, in-
cluding interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux ap-
pareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
The CE Declaration of Conformity can be obtained from Shure Incorporated or any
of its European representatives. For contact information please visit www.shure.com
The CE Declaration of Conformity can be obtained from: www.shure.com/europe/
compliance
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Jakob-Dieffenbacher-Str. 12
75031 Eppingen, Germany
Phone: 49-7262-92 49 0
Fax: 49-7262-92 49 11 4
Email: info@shure.de
Meets essential requirements of the following European Directives:
• Low Voltage Directive 2006/95/EC
• WEEE Directive 2002/96/EC, as amended by 2008/34/EC
• RoHS Directive 2002/95/EC, as amended by 2008/35/EC
Note: Please follow your regional recycling scheme for electronic waste
• Battery Directive 2006/66/EC
Please follow your regional recycling scheme for battery disposal.
• Conforms to European Regulation (EC) No. 1275/2008, as amended.
Information to the user
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installa-
tion. This equipment generates uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
6

Advertisement

Table of Contents
loading

Table of Contents