AMX Vision2 Operation/Reference Manual page 103

Note that a red horizontal line shows the current time, you can click Show Now to jump to the
current time.
2.
Move your cursor over the schedule to select the time where the recording should occur using the 24 hour
clock and click at this point. You can use the up/down cursor keys. A pop-up dialog box appears
(FIG. 96).
FIG. 96 Scheduled Recording dialog box
3.
Enter the name for the recording in the Program Name text box.
4.
Use the up-and-down arrows to change the duration of the recording in 10 minute increments up to a
maximum of 180 minutes.
You can enter a value in the Duration text box, however, Vision2 only supports
scheduled recordings in 10 minute increments. If you enter a value in the Duration
text box that isn't a 10 minute increment, Vision2 automatically rounds up to the next
10 minute increment without alerting you.
5.
Click Add, you will now see the new recording displayed in the schedule
6.
Click Save Changes to save the updated schedule. Any recordings created are placed in a folder with the
same name as the Record service inside the DVR Recordings folder.
If you disable and then re-enable a Record Service while a scheduled record is in
progress for that service then that scheduled record will not resume
2
Vision Operation/Reference Guide
Record Service
95