Operation And Use - Beem Leopard G5 User Manual

Leopard G5

Operation and use

Notes
Using as mincer
■ If you wish to make very fine mince,
you can feed the meat through several
times (initially use a perforated disc
with large holes and then one with
smaller holes).
■ You can chop the ingredients (e. g.,
onions) together with the mince.
■ Inedible parts such as bones, gristle
or tendons must be removed before
mincing.
■ Dice the meat first so that it fits into the
feed shaft.
Making sausages
■ Soak the sausage skin in lukewarm
water for 10 minutes. Push the wet
sausage skin over the sausage filling
shaft. Sausage skins can be obtained
at the butchers.
■ Season the mince and put it into the
funnel.
■ If the sausage skin is sticky, dampen it
again with a little lukewarm water.
■ Numerous recipes are available in the
Internet. For example, it is possible to
individually season each one with dif-
ferent spices until the desired flavour
has been found.
Using the Kebbe attachment
Kebbe (Kibbeh Mischwiye) is filled meat
rolls. A hollow roll is made with the Kebbe
attachment that can be cut to the desired
length and filled with various different in-
gredients (e. g., meat, vegetables). The
Kebbe portions are subsequently fried.
22
Switching the appliance on/off
Move switch B (8) followed by switch
‹
A (7) to the "ON" position to switch on
the appliance.
Move switch A (7) to position "0" (mid-
‹
dle position) to switch off the appli-
ance.
Using the appliance
Assemble the attachment as de-
‹
scribed in the section Assembling
the attachment (page 20).
Insert the plug into the mains socket.
‹
Switch on the appliance as described
‹
in the section Switching the appli-
ance on/off (page 22).
Put a suitable container under the
‹
outlet.
Cut the ingredients into pieces to fit
‹
into the feed shaft.
Add the ingredients into the feed shaft
‹
Press the ingredients downwards us-
‹
ing the pusher (2) until the feed shaft
is empty.
Eliminating blockages
Switch off the appliance as described
‹
in the section Switching the appli-
ance on/off (page 22).
Move switch B (8) to position "R".
‹
Move switch A (7) to position "R" and
‹
hold down for max. 10 seconds. When
you release the button, it springs back
to position "0".
Pull the plug out of the mains socket.
‹
BEEM - Elements of Lifestyle
EN