Appliance Description; Preparations - Beem Leopard G5 User Manual

Leopard G5

Appliance description

(See illustration on the left fold-out page)
1 Lid, pusher
2 Pusher
3 Tray
4 Release button
5 Handle
6 Motor unit
7 Switch A
8 Switch B
9 Fixture
10 feed shaft
11 Attachment
12 Drive pinion
13 Screw conveyer
14 Mincing knives
15 Perforated disc
15a Small perforated disc (Ø 3 mm)
15b Medium perforated disc (Ø 5 mm)
15c Large perforated disc (Ø 7 mm)
16 Locking ring
17 Pusher for shortbread biscuits
18 Shortbread biscuit attachment
19 Sausage filling disc
20 Kebbe attachment
21 Kebbe shaper
22 Sausage filling shaft 1
23 Sausage filling shaft 2
24 User manual (not illustrated)
Switch positions
■ Switch A (7) and switch B (8) at "ON"
position: normal operation
■ Switch A (7) at "0" position: appliance
switched off
■ Switch A (7) and switch B (8) at "R"
position: reverse operation
20
Overload protections
The motor is protected against overload-
ing by a thermal circuit breaker. It stops
automatically in the event of overloading.
In this case, switch off the appliance and
allow it to cool for approx. 60 minutes.
CAUTION
► Observe the maximum operating
time of 10 minutes.
► Allow the appliance to cool down
afterwards for 30 minutes before it is
switched on again.

Preparations

Preassembly
Using as mincer (image A)
Insert the screw conveyer (13) into the
‹
attachment (11).
Insert the mincing knife (14) with
‹
the blades facing outwards into the
square of the conveyer screw.
Put the desired perforated disc (15a,
‹
15b, 15c) onto the screw. The notch in
the perforated disc must lie over the
keyway of the attachment (image E).
Screw on the locking ring (16).
‹
Making sausages (image B)
Insert the screw conveyer (13) into the
‹
attachment (11).
Put the sausage filling disc (19) onto
‹
the screw. The notch in the sausage
filling disc must lie over the keyway of
the attachment.
Insert the desired sausage filling shaft
‹
(21, 22) through the locking ring (16).
Screw on the locking ring (16).
‹
BEEM - Elements of Lifestyle
EN