Table of Contents
Advertisement
INTRODUCTION
Thank you for your purchase of the Selectronic Sine wave inverter, model WM1200-12V.
Your WM1200 is a state-of-the-art high performance TRUE SINE WAVE DC-AC Inverter.
Many hours of development time have been invested in the WM1200 so that we can provide you with a
reliable high quality inverter. The output from your WM1200 is as good as, if not better than mains
power. If looked after properly, the WM1200 will give you many years of reliable service.
WARRANTY CARD
Before proceeding any further, it is extremely important that you complete your warranty card
NOW. This will enable us to immediately register your 5 year warranty period. By accurately
completing your warranty card, you will provide us with valuable information that will assist us in
keeping up with your alternative energy needs. Please take a few moments to fill in the warranty
card. Your efforts will be greatly appreciated.
INSTALLATION
The installation of your inverter is extremely important. Failure to follow the recommended installation
instructions may void your warranty. If in doubt, ask your supplier.
After unpacking, check for any damage that may have occurred during transit. If there are any signs of
damage, contact your supplier immediately.
The Inverter must be installed in a dry, cool, dust-free environment.
Please leave at least 300mm clearance around the sides and top of the Inverter and approximately
200mm at the base as this will aid the natural cooling of the Inverter. The air vents on the underside of
the WM1200 also need to be kept clear of obstructions.
We suggest that you house your Inverter and other power generating equipment in a purpose built shed
sited remotely from the home, and as far away as possible from any radio transmitters or receivers. Also
make sure that the exhaust from your generator or other sources of heat or fumes are kept well away
from the WM1200. SEIA (Sustainable Energy Industry Association (Australia) Ltd) installation
guidelines must be followed.
You must have a suitable 12V DC battery bank that is maintained and operated to the battery
manufacturer's recommendation. To ensure operation to WM1200 specification, the battery bank
should have a minimum capacity of 500 ampere hours at the 100 hour discharge rate 12V systems (ask
your supplier if in doubt). Smaller capacity batteries can be used but may result in degraded
performance of the WM1200 under heavy surge conditions.
300mm
ON
DEMAND START
16 Wa tts
12 Wa tts
8 Watts
4 Watts
Dema nd Start Adjust
Off
Low Volts Adjust
DC POWER
Mode
300mm
STATUS
AC Vo lts ON
DC
TO
AC
PO W E R
AC Overlo ad
DC Volts Low/High
TEMP Over load
Al arms
PROUDLY DESIGNED & MADE IN AUSTRALIA
385mm
BASE
2
30mm
160mm
Advertisement
Table of Contents
