Table of Contents
Advertisement
1.
Ensure that the doors are all closed and that the gearshift lever is in the Neutral
position.
2.
With the engine already running, apply the parking brake and release the brake
pedal.
Make sure to release the brake pedal.
3.
Within 20 sec. push
The parking lights will flash 3 times quickly and remain lit.
4.
Remove the key: the engine will go on running.
5.
Exit the vehicle and close the door.
6.
Press the
door lock is installed).
If the pre-programmed run time expires or if the user shuts down the engine by remote
control, the vehicle will get in Ready Mode.
Caution: Do not leave children or pets unattended in a car in Idle Mode.
Valet Modes
When your vehicle is in Valet Mode, the remote starter functionalities are disabled. If the
vehicle needs to be serviced, or if you park it indoors, the Valet Mode will prevent the engine
from being remote started accidentally.
Valet Mode using the Valet Button
(If installed)
To put the system into Valet Mode:
1.
Turn the key to the
2.
Press (for at least 1 second) and release the Valet Button. The LED will come
To take the system out of Valet Mode:
1.
Turn the key to the
2.
Press (for at least 1 second) and release the Valet Button. The LED will go
The Valet button can only be used if the vehicle keys are in the
Ignition Valet
The system can be placed in Valet Mode to disable the remote starting capabilities. If the
vehicle needs to be serviced, or if you park it indoors, Valet Mode will prevent the engine
from being accidentally started by remote control.
To enter Valet Mode
•
With the key in the Ignition switch, turn the key to the
positions 5 times within 10 seconds.
•
The Parking Light will flash 3 times indicating the Module is now in Valet Mode.
The LED will turn
To exit Valet Mode
•
With the key in the Ignition switch, turn the key to the
positions 5 times within 10 seconds.
•
The Parking Light will flash twice indicating the Module is now out of Valet Mode.
The LED will turn
P. 6
LOCK
button until the system is armed (the doors will be locked if remote
TRUNK
IGNITION ON (RUN)
IGNITION ON (RUN)
solid.
ON
.
OFF
,
or
UNLOCK
START/STOP
position.
position.
on the transmitter.
position.
IGNITION ON (RUN)
and then
ON (RUN/IGNITION)
and then
ON (RUN/IGNITION)
.
ON
.
OUT
OFF
OFF
User Guide
Hide quick links:
Advertisement
Table of Contents
