Diagnostics - Parking Light Flash Table - Command Start CS-396i User Manual

Diagnostics – Parking Light Flash Table
Flashes
1
2 slow flashes followed
by 8 quick flashes
2
3
4
5 Fast
6
8
10
When pressing
START
15 quick flashes...
1 – pause – 2
ON SOLID for 3
seconds....
ON continuously
ON 2 seconds
ON 4 seconds
ON 20 seconds
Constantly flashing
up to 25 sec.
User Guide
• Doors locked, starter kill armed
• Run time has expired
•
button pressed
TRUNK
• Start signal received by the module
• Cold weather mode cancelled
• Reset from manual to automatic
• Doors unlocked, starter kill disarmed
• Remote start attempt cancelled by
remote
• Exiting ignition valet
• Entering and exiting ready mode.
• +12 V detected on the brake input wire either while cranking or during run time
• Entering multi-speed tach programming
• Board set from automatic to manual; power ON
• Power ON to OFF (manual transmission)
• Tach signal programmed
• New transmitter programmed
• A remote start was attempted while a tach-before-crank signal was detected before cranking
• Unit reset
• A ground (-) signal was detected on the hood pin input wire when attempting to remote start or
during run time
• The parking brake is connected to ground (automatic transmission)
• There was a remote start attempt while the vehicle was in valet mode
• Failed start: vehicle's low battery voltage
...followed by 1 flash
...followed by 3 flashes
• Idle mode: Idle mode is engaged
•
Run time: The vehicle has been remote started and is in run time
• The hood has been opened and a ground (-) signal has been detected on the hood pin input wire
• Locking or unlocking a door (with door pulses configured to 4 sec.)
• The hood pin has been flashed and you are now in the programming options
• Panic mode is triggered
Description
• Power-up reset
• Board set from manual to automatic; power
ON
• Power ON to OFF (automatic transmission)
• Entering ignition valet
Exiting cold weather mode
Entering cold weather mode
P. 11