Table of Contents
Advertisement
switch
on certain types of vehicles could cause them to remain
ON
starter shuts down, resulting in a dead battery.
Arming the Starter Kill
If installed, the Starter Kill can be programmed to arm in Active Mode (will not arm
automatically) or in Passive Mode (will arm automatically).
• To disarm the Starter Kill in Active or Passive Mode, press the
mitter. The parking lights will flash twice. (If Remote Door Locks were installed, this will
also unlock the doors.) In Passive Mode, the system will automatically rearm 1 or 3
minutes after the doors were unlocked.
• To arm the Starter Kill in Active or Passive Mode, press and hold the
transmitter. The parking lights will flash once. (If Remote Door Locks were installed, this
will also lock the doors). In Passive Mode, the system will automatically arm 1 or 3 minutes
after the engine is shut down.
Remote starting Your Vehicle
If your vehicle has an automatic transmission, simply press the
or stop your vehicle. Skip the next steps on to "Remote starting".
Warning: If you vehicle has an automatic transmission and the parking lights flash 15 times
after pressing the
that you see your installer and have him disconnect the wire.
Setting Your Vehicle into Ready Mode
If your vehicle has a manual transmission you must read the following indications. In order
to start the vehicle by remote, the unit must first be set to Ready Mode. If the unit is not set to
Ready Mode, it cannot remote start the vehicle.
Please note that Ready Mode can be enabled by the remote or the handbrake,
depending on the option that was selected by your installer. Therefore, you must
follow the appropriate procedure between the two described below in order to set your
vehicle into Ready Mode.
Once the system is set to Ready Mode, the vehicle can be remote started and stopped at
any time. The system will exit Ready Mode if a door, the hood or the trunk is opened, if the
brake pedal is pressed, if the parking brake is disengaged or if the ignition key is turned to
the
IGNITION ON (RUN)
To set the system to Ready Mode:
If Ready Mode is enabled by remote
1.
Ensure that all the doors, hood and trunk are closed. Make sure that the gear selector is in the neutral
position.
2.
With the engine already running, apply the
parking brake once and release the brake
pedal.
Make sure to release the brake pedal.
3.
Within 20 sec. of engaging the parking brake,
press and hold
START/STOP
The parking lights will flash 3 times
P. 4
button, the parking brake is connected to ground. It is imperative
START
position.
,
or
LOCK
UNLOCK
on the transmitter.
UNLOCK
START
If Ready Mode is enabled by handbrake
2.
With the engine already running, apply the
parking brake twice and release the brake
pedal.
Make sure to release the brake pedal.
The parking lights will flash 3 times
quickly and remain lit.
Skip to step 4.
even after the remote
ON
button on the trans-
button on the
LOCK
button to remote start
-
User Guide
Hide quick links:
Advertisement
Table of Contents
