Replacement Of Valve Rocker Seals; Replacing The Rod Seal; Assembly - WAGNER AC 4600 Professional Operating Manual

EDITION 06/2012
OPERATING MANUAL
6.4.2

REPLACEMENT OF VALVE ROCKER SEALS

1. Support valve tappet (50) with single open-end wrench with wrench size
13 mm; 0.51 inches and unscrew cover (53) with single open-end wrench
with wrench size 7 mm; 0.28 inches.
2. Remove air valve seal (51) and seal (52) and replace with new seals.
3. Screw valve tappet (50) and cover (53) together by hand. Carefully tighten
in small increments with open-end wrench with wrench size 7 mm; 0.28
inches and with wrench size 13 mm; 0.51 inches until a slight resistance
is perceptible when moving the valve rod (34) in the valve tappet.
Note:
The seal (52) can be pulled out of the cover (53) with the help of an eyebolt.
6.4.3

REPLACING THE ROD SEAL (35)

1. Carefully pull the rod seal (35) out of the gun housing.
2. Clean sealing surfaces in the gun housing.
3. Mount new rod seal (35) to the rod seal tool (84).
Note
Installation position of the
rod seal (35)
4. Insert rod seal tool (84) together with rod seal (35) into the hole.
5. Fit trigger guard (21) with screw (22) to body of gun and
6. Carefully push the tool with the rod seal (35) over the trigger guard (21)
into the recess in the housing.
7. Remove trigger guard (21), screw (22) and rod seal tool (84).
6.4.4

ASSEMBLY

1. Fit seal collar (11) to valve rod (14), together with inserted O-ring (12) and sealing screw
(10).
2. Push completely assembled valve tappet (19) onto valve rod (14).
3. Insert preassembled valve rod into the collet chuck (18) as far as the stop.
4. Fix clamping sleeve (4) with wrench size 6 mm; 0.24 inches, screw the preassembled
valve rod to the clamping sleeve and tighten (open-end wrench with wrench size 5
mm; 0.20 inches).
5. Carefully insert the complete valve rod (B) into the gun housing.
6. Screw in sealing screw (10) but do not tighten yet.
7. Position trigger guard (21) and secure with screw (22) and nut (20).
8. Insert compression springs (3) and (2) and screw on the spring cover (5).
9. Carefully tighten the seal collar (11, 12) by turning the sealing screw (10). Ensure that
the trigger guard moves easily.
10. Start up in accordance with chapter 5.3.
Note:
Only use silicone and resin free grease.
PART NO. DOC394871
B_02688
AC 4600 Pro
22
84
35
Spraying direction
50
51
52
53
B_02274
21
B_02268
31