AT&T 1070 User Manual page 91

Appendix J
In case of difficulty
Common cure for
electronic equipment:
The answering system
does not respond to
internal access commands.
Some messages for
specific extensions were
not recorded.
My phone beeps for no
reason.
If the telephone is not responding normally, try
the following (in the order listed):
1. Disconnect the power to the telephone base.
2. Disconnect the spare battery (if the set has
one).
3. Wait a few minutes before connecting power to
the telephone base.
4. Re-install the spare battery (if the set has one).
5. Wait for the telephone to synchronize its
connection. This may take up to one minute.
• Make sure your remote access code is correct
(see the installation guide for more details).
• If you access the extension mailbox through a
single page call, make sure the extension
number of the extension mailbox is entered
correctly.
• The extension mailbox is in use. Or the two
intercom paths are in use. Wait for a few minutes
then try again.
• There may be interference on the telephone line you
are using. Press the dial pad keys firmly when dialing.
• Check the central (general) mailbox(es) for the
messages.
• Check Line Group setting (see page 43 of the
installation guide for directions).
• If someone is trying to assign your phone's
extension number to another phone, your phone
will sound a warning beep, and display, "IS
ALREADY USED."
85