Marine PC MPC-AWMVRL User Manual page 26

TSHARC Installation
If you need to cancel this driver installation at any time, select the Cancel button on
the driver installation dialog screen.
CAUTION!
Select Controller
1. The TSHARC Driver is a 12-bit controller; the radio button is selected by default
Note: A PS/2 controller interface is not available.
2. Select the controller interface matching the
cable used to install the MPC-AWMVR
3. Select the Autodetect button if installing the
Touch Screen through a RS-232 (serial)
interface
4. There are two options for RS-232 installation:
Autodetect and Manual. Manual instructions
are found in section Manual RS-232 Controller
Set-up
5. If connecting through a USB interface, select
the USB radio button
6. Select Next
7. Following installation, select Finish, and
8. Reboot the computer when prompted.
Autodetect RS-232 Controller Set-up
1. Select the Autodetect button
2. The "AutoDetect Serial" dialog box lists the
detected RS-232 controller information. Select
OK
3. "Installing Touch Screen Driver" text box pops
up, indicating the progress of the installation
4. Following installation, select Finish, and
5. Reboot the computer when prompted.
26
MPC-AWMVRL-UM(B) 1/2011
1. At the Welcome screen, select Next to go to the
Software License Agreement (EULA)
2. After reading the EULA, if in agreement, check
the box "I accept all of the terms..."
3. Select Next.
Note: Any unlawful use of the TSHARC driver is a strict
violation of the United States and International copyright
laws. Using a TSHARC driver with any third party Touch
Screen is strictly prohibited.