Auto Color - Marine PC MPC-AWMVRL User Manual

OSD Source Screen Menu Parameter Selections
• New settings shall be stored in memory upon pressing the SELECT button to
exit the Source OSD Source Screen Category's Function Menu.
CAUTION!
• If SELECT is not pressed, or inactivity is detected within the 15 second factory
default OSD duration, any function adjustments made shall not be saved.
It is recommended to adjust the LED back light brightness to maximum before
fine-tuning the OSD Source Screen Menu Picture Menu Parameter: Brightness.
Picture Menu Parameters
Brightness
Before adjusting the Brightness function parameters, set the LCD panel backlight
brightness using the control toggle (large sun/small sun); set to its brightest (large sun
button) in the ambient light source.
• Open the "Brightness" function
• Press the UP or DOWN buttons to set the Display's desired brightness, and
• Adjustments go from very dim (black) to 100%, very bright (dazzling white).
Contrast
Contrast is the difference in brightness between the light and dark areas of the pixels
of a picture.
• Open the "Contrast" function
• Press the UP or DOWN buttons to set the Display's desired contrast, and
• Predefined minimum to maximum is in the display bar.
Saturation
Saturation is the vividness or intensity of the hue or color.
• Open the "Saturation" function, and
• Press the UP or DOWN buttons to set the Display's desired saturation.
Tint
Tint is the pinks, blues and greens of the Display.
• Open the "Tint" function
• Press the UP or DOWN buttons to set the Display's desired tint, and
• Ranges on the Display bar are: low – pinks; mid-range – blues and upper – greens.
Sharpness
• Open the "Sharpness" function
• Press the UP or DOWN buttons to select a desired sharpness for the Display, and
• Sharpness choices in the Display bar are preset at - 0, 33, 66 and 100%.

Auto Color

• Auto Color is best calibrated from an all-white background. From the VGA video
source, create an all-white background
• Open the "Auto Color" function
• Press the SELECT button to run the Auto Color Setup. Repeat twice, and
• When complete, press the SELECT button to save the changes and exit.
20
MPC-AWMVRL-UM(B) 1/2011